Sizes

 

Ironing board covers cost £16
Click on this link to see the designs and buy online


Stock availability.
All sizes are available in the Ripple and Raspberry Ripple designs.


Blip covers are designed for the standard bullet shaped board and are secured with a drawstring. Drawstring covers usually work best with a board that has an ironing rest / plate at the blunt end.

If you require an elasticated cover or have a non standard shaped board take a look at ironingboardcovers.co.uk

To guarantee sending you the correct size, we require the measurements of the width and length of your ironing board surface in cm to be entered during checkout.

BOARD SIZE, NOT THE COVER SIZE PLEASE!


To work out the correct cover size for your board we add 10 cm on to the measurement of the width to allow for the depth of each side and to pull under the ironing board.
Then we add 5cm to the measurement of the length. This will give the correct cover size.

If a cover is the correct fit for the width of your board but is too long it can easily be cut down to fit the length. We will enclose instructions on how to do so with your cover.

This board has an ironing plate so will require a cover in a Drawstring fit (which is the style of cover we supply).
The position of the drawstring is shown by the red line. To fit the cover pull on the strings and tie under the board.
The blunt end of the cover tucks inbetween the ironing plate and the end of the board.


This board has no ironing plate so will require an Elasticated cover. The elastic is gathered all the way around the board as shown by the red line.

WE DO NOT SUPPLY ELASTICATED COVERS
PLEASE GO TO OUR MADE TO MEASURE SERVICE AT
ironingboardcovers.co.uk